How to make the headset cord not tangled?

If you ever get upset every time you troubleshoot the headphone strings, the following information will be helpful.

>>>Simple way of cleaning headphones

Recently, Material Scientists at the University of California (USA) have a report regarding the tangled strings of headphones. If you do not pay attention, many people still think it is normal to have a tangled headset cord, but standing at a scientific perspective, it is easy to have a headset easily and frequently tangled.

According to the report, one of the scientific explanations for this phenomenon is the vibration of strings. Moreover, with the design of 3 Y-shaped fibers, they are more easily hooked together to form uncomfortable knots.

In particular, the report also pointed out that earphones with a length of less than 46cm are rarely tangled, but from 46cm to 150cm, this phenomenon is very likely to occur. Therefore, in order not to be irritated every time you troubleshoot the headset cord, you can take some of the following measures.

1. Use a headset wire below 46cm

The headphone cord length is counted as the longest of either headset segment plus the jack section. You can choose a headset cord with a length of less than 46cm as reported by scientists to limit the phenomenon of 3 tangled strands overlapping. In addition, choosing a headset with a large version also helps limit this phenomenon.

2. Store the headphone cord in a place with little vibration

Also, thanks to the information from the report above, keep your headphone strings in a cabinet, put on a table, . or somewhere without frequent vibrations. As a result, when you need to use it again, you just plug the headset into the device and use it as if it was still stored.

3. Fix the headphone cord into a bundle

In case you have to move many places with a headset in a backpack or bag, fold them up in a folding way to 1/2, 1/4, 1/8, . until you reach the size just right - about the middle finger. It is important to use a rubber band or wire (with external paint) to tie it in the middle to fix the upper segments in the bundle.

4. Disconnect the headset cord directly before using or storing it

Very simply, you just need to hold the jack up high and let the two segments fall vertically. At this point, the strings that tend to be twisted will be released. Thus, you can use it without getting entangled or appearing difficult to see. Similarly, before storing, you should also perform this operation.